Description
Water-borne acrylate stain for interior use.
Product features
Parquet floors and floor boards. Suitable for sanded wooden floors prior to treatment with Parquet-Ace Floor Lacquer. Test the product on a small area to be sure that it is suitable for the surface. The product is not suitable for diamond pine, smoked oak and brown beech surfaces.
Recommended uses
Parquet floors and floor boards.
Colour Range
Tikkurila wood stains and lacquers colour card
Building material emission class
M1
Coverage
15 - 20 m2/l brush application. 20 - 25 m2/l Flotex spreader application
Application method
Application with a Flotex spreader or wide brush in the direction of the grain.
Drying time at 23°C and 50% relative air humidity
Dust dry after approx. 1 hour. The second coat can be applied after 3-4 hours. Finishing with Parquet-Ace Floor Lacquer 3-4 hours after application of the second coat.
Density
1.0 kg/l, ISO 2811
Storage
Protect from frost.
Application conditions
The wooden surface has to be dry and free from dirt, wax and grease. The temperature of the air and surface should be +15-20 °C, and the relative humidity of the air 30-80 %.
Preparation
Before you start, check the suitability and the colour of the stain on your floor by lacquering a small test area. The final colour depends on the wood, its hardness and original colour and also the number of coats applied.
Staining
Stir the priming lacquer thoroughly before and occasionally during application to ensure that the colourant is well-mixed in the lacquer. Apply a thin coat using a flotex spreader in the direction of the grain. Plan work carefully to ensure that the stain can be applied on one uniform surface without interruption. Floor boards can be treated board by board using a brush. The second coat can be applied after 3-4 hours.
Overcoating
Finish with Parquet-Ace Floor Lacquer 3-4 hours after application of the second coat.
Surface treatment
See the product data sheet of Parquet-Ace Floor Lacquer, directions of use. Stained surface has always to be treated with a finishing lacquer.
Cleaning of tools
Clean tools with water or with Tikkurila Pensselipesu (Tool Cleaner).
Maintenance instructions
The stained and lacquered surface achieves its final hardness and chemical resistance after appox. one week from finishing. Avoid cleaning during this time. Clean the surface with a brush, mop or dust towel. Dirty surfaces can be cleaned with neutral (pH 6-8) detergent and damp cleaning tool.