Fast-setting cementitious adhesive for laying ceramic tiles, stone and moisture-sensitive natural stone. Jointing can be carried out as soon as 2–4 hours. Also for exterior applications.

Special features

• allows grouting soon after tiling
• dust-reduced
• non-sagging adhesive for ceramic tiles, decoration stones and stone
• C2FTES1
• low consumption

Application

Very fast-setting and non-sagging cementitious adhesive for laying ceramic tiles, clinker and stone on vinyl, paint, tile, clinker, construction boards and common aggregate surfaces as well as on surfaces treated with Kiilto waterproofing membrane or Kiilto Kosteussulku moisture barrier. Suitable for interior and exterior use. Not suitable for areas permanently under water (e.g., swimming pools).

The surfaces to be tiled must be clean and free from dust. Remove water-soluble smoothing and levelling compounds. Dry and absorbent surfaces must be moistened or primed with thinned Kiilto Start Primer. Board substrates are primed with undiluted Start Primer. Turn off floor heating approx. 24 hours prior to tiling. When tiling on vinyl, paint, tile and clinker substrates (only interior applications):

- ensure that the surface to be tiled adheres properly to its own substrate
- remove wax, grease and dirt from the surface with alkaline cleaner and rinse well.

After the surface has dried, sand it, if necessary, and then remove the sanding dust.

Coverage

Approx. 3 kg/m² when applied using a standard notched trowel (notching: 6 mm x 6 mm x 6 mm).
Approx. 2 kg/m² when applied using a mosaic trowel (notching: 4 mm x 4 mm x 4 mm).