Categories chevron down Created with Sketch.

Your cart is empty

To add products to cart, please visit our product catalog.

Sakret BAK-F 25kg, Reinforcement / adhesion mortar for use in low temperature conditions

Article: 1008695

Category: Adhesive and reinforcement mortars, Adhesive and reinforcement mortars

Unit: pc.

Barcode: 4751006563704

9,50 €/pc.
Available in stores:
Mūkusalas iela 93
Ata iela 5a
t/c Sāga

For work at low air temperatures from 0°C to +20°C

For adhesion and reinforcement of stone wool and polystyrene thermal insulation panels

Cement based

Reinforced with polypropylene fibre

With adhesion and flexibility improving additives

Water vapor permeable. Water and frost resistant

Grey colour


Surface preparation
• Surfaces must not be covered with frost, ice or snow and the surface temperature must be ≥2°C
• The base must be dry and firm, all cracks and voids must be filled
• Clean the substrate from loose and/or separable layers
• Particularly dense and/or smooth surfaces should be treated with an abrasive material
• Highly absorbent surfaces must be primed with SAKRET BG primer or SAKRET UG primer (diluted 1:3)
Reinforcement of thermal insulation panels
• Apply SAKRET BAK-F on the heat insulation plate in an even layer (up to 5mm), pull it out with a toothed trowel, embed the alkali-resistant reinforcing mesh in the mass and level it with the flat trowel so that the reinforcing mesh is completely covered with SAKRET BAK-F
• If the thermal insulation panel is made of mineral wool, then SAKRET BAK-F is first rubbed into the surface of the board
Adhesion of heat insulation panels
• If the wall is flat (unevenness <10mm/m), then apply SAKRET BAK-F with a toothed spatula (tooth size - 10mm) on the entire surface of the thermal insulation board and stick it to the base
• If the wall is uneven, then apply SAKRET BAK-F to the edges of the thermal insulation plates (~5cm wide and 2cm high) and put 6 balls of the material on the surface of the plates, then stick to the wall
• If the thermal insulation panel is made of mineral wool, then SAKRET BAK-F is first rubbed into the surface of the panel


• 25 kg / paper bags / 48 bags on a pallet

Tehnical data 

Chemical composition: cement, special inert additives, auxiliaries and adjuvants for improving treatment properties

Weight 25.00 kg
Dimensions 52 x 31 x 11 cm