Usage details

Places of use:
For the water vapor permeable covering of window and door joints from the outside.

Instructions: The tape can be applied to the window before or after installing the window (based on our experience, we recommend doing this before installing the window).
• Window frames must be clean, dry and strong (stiff and dust-free).
• Remove a part of the protective film from the end of the tape (the side of the tape that you will stick to the window frame) and then stick the tape to the frame, do not leave wrinkles and do not stretch too much. Leave the tape at least 3 cm from the corner of the window frame.
• Fix the window in the opening and fill the installation joint between the window frame and the opening with foam.
• After the foam has set and cut off the excess foam, remove the protective film from the tape and stick the tape over the opening.
• The tape must be glued to the surface in its entirety, without leaving any air gaps. We recommend using a stiff roller or a soft putty trowel for leveling and tamping the tape.
• To compensate for the movement of building parts, do not stretch the tape too much when sticking.
• Protect the joint from rain (approximately 5 hours) to allow the adhesive to harden.
• Gypsum board does not change the physical properties of the tape. • Attention! If necessary, the tapes can
be glued together to obtain the required wider width.