Categories chevron down Created with Sketch.

Your cart is empty

To add products to cart, please visit our product catalog.

Tikkurila PANEELI-ÄSSÄ 10 EP 2.7L matt lacquer

Article: 1303941

Category: Wall lacquer

Unit: pc.

Barcode: 6408070025376

27,90 €/pc.
Available in stores:
Pre-order only!
Waterborne, tintable, low-odour acrylate lacquer for use on dry interior wood surfaces.
Product features
Interior wood panelling, walls, ceilings, log, concrete and brick surfaces.  Not suitable for use on floors and furniture.
Recommended uses
Panel walls and ceilings as well as log surfaces.

The paint is suitable for interior walls The paint is matt The paint is water-borne Tool: spray Tool: brush 
The coverage of the paint on rough surfaces

The coverage of the paint on smooth surfaces
Base paints
Colour Range
Tikkurila Interior Lacquer Colour Card.
Gloss grade
Building material emission class

8-12 m2/litre per coat on planed surfaces.
Can sizes
0.9 l, 2.7 l, 9 l
Application method
Brush or spray. 
Drying time at 23°C and 50% relative air humidity
Normally touch-dry in ½ hour and recoatable after 2-3 hours. Ready to use the following day. The lacquered surface will reach its final hardness after approximately 1 month. 
Solids volume
22 %
n. 1.0 kg/l, ISO 2811
Protect from frost.
Product code

Application conditions
All surfaces to be painted must be dry, the temperature of the air and substrate at least +10ºC, and the relative humidity of the air 30 - 80%.
Untreated wood surface: 
Clean surface from dirt and dust. Wet new wood surfaces with clean water so as to expose loose wood fibres, allow to dry and sand down. Remove sanding dust. 
Previously lacquered surface: 
Wash down previously lacquered surface with Maalipesu Cleaning Agent and rinse carefully with water. Completely remove existing coatings that are in poor condition using a paint removal solution or by sanding. Treat as a new wood surface. 
Stir thoroughly before and during use. Thin with water, if necessary. Apply two coats in the direction of wood grain. If you use a tinted product, make a trial application on a separate piece of wood to be sure of the right colour. The final colour will depend upon the timber species, i.e. original colour and hardness as well as number of coats applied. Thin the tinted lacquer with 20-30 % of water for the first coat. The chosen colour and gloss level will normally be achieved after the application of two coats. Always treat the surfaces without a break and large panel surfaces few panels at a time to achieve a uniform colour.
Cleaning of tools
Clean tools with water immediately after use. Tikkurila Pensselipesu (Tool cleaner) is recommended to be used for cleaning hardened paint from tools.
Maintenance instructions
Earliest 1 month after treatment: 
Clean the surfaces with a damp sponge, cloth or soft brush and with neutral (pH 6-8) detergent. The surface must not be left wet after cleaning. Very dirty surfaces can be cleaned with a slightly alkaline (pH 8-10) detergent using e.g. a cloth or a sponge. Rinse the surface carefully. 
Maintenance treatment
Surfaces treated with Paneeli-Ässä can be maintained with Paneeli-Ässä or with a similar water-borne lacquer.
Weight 3.00 kg
Dimensions 18 x 18 x 18 cm