Waterborne, tintable, low-odour acrylate lacquer for use on dry interior wood surfaces.
Interior wood panelling, walls, ceilings, log, concrete and brick surfaces. Not suitable for use on floors and furniture.
Panel walls and ceilings as well as log surfaces.
Tikkurila Interior Lacquer Colour Card.
Building material emission class
8-12 m2/litre per coat on planed surfaces.
0.9 l, 2.7 l, 9 l
Brush or spray.
Drying time at 23°C and 50% relative air humidity
Normally touch-dry in ½ hour and recoatable after 2-3 hours. Ready to use the following day. The lacquered surface will reach its final hardness after approximately 1 month.
n. 1.0 kg/l, ISO 2811
Protect from frost.
All surfaces to be painted must be dry, the temperature of the air and substrate at least +10ºC, and the relative humidity of the air below 80%.
Untreated wood surface:
Clean surface from dirt and dust. Wet new wood surfaces with clean water so as to expose loose wood fibres, allow to dry and sand down. Remove sanding dust.
Previously lacquered surface:
Wash down previously lacquered surface with Maalipesu Cleaning Agent and rinse carefully with water. Completely remove existing coatings that are in poor condition using a paint removal solution or by sanding. Treat as a new wood surface.
Stir thoroughly before and during use. Thin with water, if necessary. Apply two coats in the direction of wood grain. If you use a tinted product, make a trial application on a separate piece of wood to be sure of the right colour. The final colour will depend upon the timber species, i.e. original colour and hardness as well as number of coats applied. Thin the tinted lacquer with 20-30 % of water for the first coat. The chosen colour and gloss level will normally be achieved after the application of two coats. Always treat the surfaces without a break and large panel surfaces few panels at a time to achieve a uniform colour.
Cleaning of tools
Clean with water immediately after use. Tikkurila Pensselipesu (Tool cleaner) is recommended to be used for cleaning hardened paint from tools.
Earliest 1 month after treatment:
Clean the surfaces with a damp sponge, cloth or soft brush and with neutral (pH 6-8) detergent. The surface must not be left wet after cleaning. Very dirty surfaces can be cleaned with a slightly alkaline (pH 8-10) detergent using e.g. a cloth or a sponge. Rinse the surface carefully.
Surfaces treated with Paneeli-Ässä can be maintained with Paneeli-Ässä or with a similar water-borne lacquer.