TECHNICAL DATA

White F497

Full-matt

7 m²/l  (minimum amount to be applied 260 g/m², wet film thickness 200 µm, dry film thickness 75 µm)

1, 3 and 10 L

Water

To be used unthinned.

Brush, roller or spray gun.
Airless spray:
- nozzle 0.015" 0.019"
- thinning 0-10 vol %

Touch-dry after approx. one hour. 
Recoatable the following day.

38 %

1.3 kg/l, ISO 2811

Protect from frost.

The surface to be painted must be dry, the temperature at least +10°C, and the relative humidity of the air less than 80 %. A low temperature (approx. +15°C) and higher humidity (50–70 % RH) will extend the working time and make application easier.

In order to ensure the best possible adhesion, clean new wooden surfaces from any dirt and dust. 
Wash previously painted or lacquered surfaces with neutral detergent according to need. Allow to dry. Remove loose paint or lacquer and sand the whole surface – especially floors and furniture. Remove sanding dust. If necessary, use Presto Rapid Filler to fill any cracks and dents, and sand the filled areas. Remove sanding dust. Patch paint with primer on bare wood surfaces. 

Note! The adhesion of Multistop to certain parquet lacquers is poor, therefore the parquet lacquer should be completely removed, if Multistop is used over the entire surface.

Stir Multistop well before use. The product is used without thinning. Apply plenty of the paint and treat 1-2 times, preferably with a thick nap roller and finish the surface immediately with a synthetic brush. The best insulation result is achieved when the treatment is performed twice. Allow the surface to dry until the following day before the second coat. Thus it forms the best protection against discoloration from the wood.

Remove any excess paint from tools. Wash the tools with water. Tikkurila Pensselipesu (Tool Cleaner) is recommended for removing slightly hardened paint.

After the surface treatment, surfaces must be handled with care for a few weeks, as the product will reach its final hardness and durability under normal conditions after about a month. 
About a month after painting at the earliest, if necessary, clean the surface using neutral (pH 6–8) dishwashing liquid solution and a soft brush, sponge or cloth. Clean soiled surfaces using mild alkaline (pH 8–10) detergent solution and a cloth, mop or sponge, for example. Rinse the surface carefully.